This will simply initiate the download of its firmware update. The only difference is that instead of the Volume Down button, you need to press the Home button (with Power button).Ĥ. The same can be done for other devices (iPhone 6s and older generations) as well. Keep pressing the Volume Down button till your phone will be restarted in DFU mode. After holding them simultaneously for 10 seconds, let go of the Power button. If you own an iPhone 7 or later generation device, then press and hold the Volume Down and the Power button at the same time. If the phone is connected but not detected by Dr.Fone, you have to check if the phone is in DFU mode. When you are ready, click on the “Start” button. On the next screen, you can verify important details related to your device. Afterward, you can just click on the “Standard Mode” button.ģ. Using a lightning or USB cable, connect your iPhone to the system and wait for it to be detected automatically. From its welcome screen, you need to pick “System Repair” option.Ģ. To start with, you need to launch Dr.Fone on your Mac or Windows PC. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup.1. Note: When using recovery mode, you can only restore the device. If you see the Connect to iTunes screen but the device does not appear in iTunes, follow these troubleshooting steps if you're using a Mac, or these steps for Windows computers. You must restore this iPhone before it can be used with iTunes." Note: If iTunes not open after two minutes, please open iTunes yourself. "iTunes has detected an iPhone in recovery mode. iTunes should automatically open and display the following message:.If you don't see the Connect to iTunes screen, try these steps 1 through 4 again. Note: If the image of a battery appears, let the device charge for at least ten minutes to ensure that the battery has some charge, and then start with step 2 again. When this screen appears, you can release the Home button: Continue holding the Home button until you see the Connect to iTunes screen.While pressing and holding the Home button down, connect the USB cable to the iPhone, iPad, or iPod touch.When the device turns off, release the Sleep/Wake and Home buttons. If you cannot turn off the device using the slider, press and hold the Sleep/Wake and Home buttons at the same time. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider.Connect your USB cable to your computer but not to the iPhone, iPad, or iPod touch until step 3.How to perform a recovery-mode restore If your iPhone, iPad, or iPod touch is already showing the "Connect to iTunes" screen, please go to step 5. Automatically goes into recovery mode after having an issue while installing an update or performing a regular restore.Is no longer recognized in iTunes after an update or restore did not complete.Restarts but never displays the Home screen.Displays the Apple logo with no progress bar or a stopped progress bar for over ten minutes.You may need to perform a recovery-mode restore if you experience any of the following situations on your iPhone, iPad, or iPod touch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |